Sanyo PLC-WXE46 - Manual (Page 12)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
12/65
6. Status Read Command Table
6.1 Image Status Read Command Table
Status read command Item
CR_BRIGHT[CR] Get Brightness value
CR_CONT[CR] Get Contrast value
CR_COLOR[CR] Get Color value
CR_TINT[CR] Get Tint value
CR_SHARP[CR] Get Sharpness value
CR_GAMMA[CR] Get Gamma value
CR_WBAL-R[CR] White Balance Red value
CR_WBAL-G[CR] White Balance Green value
CR_WBAL-B[CR] White Balance Blue value
CR_COLTEMP[CR] Get setting value of Color temperature
CR_NZRED[CR] Get setting status of Noise reduction
CR_PROGV[CR] Get setting status of Progressive scan
CR_IMAGE[CR] Get Selected Image status
CR_IMGGMD[CR] Get setting value of Image Gamma
6.2 PC Adjust Status Read Command Table
Status read command Item
CR_FSYNC[CR] Get setting value of Fine Sync
CR_TDOTS[CR] Get setting value of Total Dots
CR_CLAMP[CR] Get setting value of Clamp
CR_H-POS[CR] Get setting value of Horizontal Position
CR_V-POS[CR] Get setting value of Vertical Position
CR_DDOTS[CR] Get setting value of Display Dots
CR_DLINE[CR] Get setting value of Display Line
CR_PCSTORE[CR] Get Free or Stored status for PC Adj. mode1-5
6.3 Video Status Read Command Table
Status read command Item
CR_SERSYS[CR]
Get selected current signal. When in Auto mode, it returns a
result by Auto detect.
6.4 Input Status Read Command Table
Status read command Item
CR_INPUT[CR] Get selected Input No.
CR_SOURCE[CR] Get selected source of currently selected Input
CR_SRCINP1[CR] Get selected source of Computer 1
CR_SRCINP2[CR] Get selected source of Computer 2
CR_SRCINP3[CR] Get selected source of Video
CR_SYSTEM[CR] Get selected system status in Input mode
CR_SYSLIST[CR] Get selectable System table
CR_MODELIST[CR] Get selectable Mode table