Sanyo PLC-WXE46 - Manual (Page 25)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
25/65
8.6.7 CF_SYSTEM Command
Command “CF_SYSTEM_%1”[CR]
%1
Input is
Computer
“VGA1” ------------- Select VGA1
:
“XGA1” ------------- Select XGA1
:
“WXGA3” ------------ Select WXGA3
“1080I” --------------- Select 1080I
“1035I” --------------- Select 1035I
“720P” ---------------- Select 720P
”575P” ---------------- Select 575P
”480P” ---------------- Select 480P
”575I” ----------------- Select 575I
”480I” ----------------- Select 480I
“MODE1”~ “MODE5”------------- Select Mode 1~Mode 5
Input is
Video
“AUTO” -------------------------- Select System “Auto”
“NTSC” -------------------------- Select NTSC
“NTSC443” --------------------- Select NTSC4.43
“PAL” ----------------------------- Select PAL
“SECAM” ----------------------- Select SECAM
“PAL-M” ------------------------- Select PAL-M
“PAL-N” ------------------------- Select PAL-N
“1080I” -------------------------- Select 1080i
“1035I” -------------------------- Select 1035i
“720P” --------------------------- Select 720p
“575P” --------------------------- Select 575p
“480P” --------------------------- Select 480p
“575I” ---------------------------- Select 575i
“480I” ---------------------------- Select 480i
Details
Select System of currently selected Input
When Input specified by %1 is inappropriate for selected Input, the projector
returns “101”[CR] and the command is not executed
This command is available in normal Power ON status.
Note1) “NTSC” / ”NTSC4.43” / ”PAL” / ”SECAM” / ”PAL-M” / ”PAL-N” is available
only when Input is VIDEO / S-VIDEO
Note2) “1080I” / ”1035I” / ”720P” / ”575P” / ”480P” / “575I” / “480I” is available only
when Input is Y / Pb/Cb / Pr/Cr
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]