Sanyo PLC-WXE46 - Manual (Page 58)

PLC-WXE46/WXL46 Expand Serial Command Functional Specifications
58/65
9.11.10 CR_STANDBYMODE Command
Command “CR_STANDBYMODE” [CR]
Details Get Standby Mode setting status
Response
Acceptable “000_%a”[CR]
%a
“ECO” -------------- Eco Mode
“NORMAL” -------- Normal Mode
Unacceptable “Error Code”[CR]
9.11.11 CR_P-MANE Command
Command “CR_P-MANE”[CR]
Details Get Power management setting status
Response
Acceptable “000_%a”[CR]
%a
“OFF” -------------------------- Power Management is OFF
“READY” ---------------------- Power Management is Ready
“SHUTDOWN” ---- Power Management is set to Shut Down mode
Unacceptable “Error Code”[CR]
9.11.12 CR_P-MANETIME Command
Command “CR_P-MANETIME”[CR]
Details Get time to start Power Management
Response
Acceptable “000_%a”[CR]
%a “001”~”030” -----------------------1 minute to 30 minutes
Unacceptable “Error Code”[CR]
9.11.13 CR_ON-STA Command
Command “CR_ON-STA”[CR]
Details Get Power ON Start setting status
Response
Acceptable “000_%a”[CR]
%a
“ON” -------------------------- Power ON Start is ON
“OFF” ------------------------ Power ON Start is OFF
Unacceptable “Error Code”[CR]
9.11.14 CR_RCODE Command
Command “CR_RCODE”[CR]
Details Get selected Remote Control Code
Response
Acceptable “000_%a”[CR]
%a
“001” --------------------------- Code1 is selected
“002” --------------------------- Code2 is selected
Unacceptable “Error Code”[CR]