Krell Industries 7.1 - Manual (Page 2)

Home Theater Standard 7.1
Surround Preamp/Processor
Instructions for Use
v 02.3
Krell Industries, Inc.
45 Connair Road
Orange, CT 06477-3650 USA
TEL 203-799-9954
FAX 203-891-2028
E-MAIL [email protected]
WEBSITE http://www.krellonline.com
This product complies with the EMC directive (89/336/EEC) and the low-voltage
directive (73/23/EEC).
The Home Theater Standard 7.1 must be placed on a firm level surface where it is
not exposed to dripping or splashing.
The ventilation grids on the top and bottom of the Home Theater Standard 7.1
must be unobstructed at all times during operation. Do not place flammable mater-
ial above or beneath the component.
Do not remove or bypass the ground pin on the end of the AC power cord. This
could cause radio frequency interference (RFI) to be introduced into your playback
system.
Before making connections to the Home Theater Standard 7.1, make sure the back
panel power switch is off. Make sure all cable terminations are of the highest quali-
ty and free from frayed ends, short circuits, or cold solder joints.
THERE ARE NO USER SERVICEABLE PARTS INSIDE ANY KRELL PRODUCT.
Please contact your authorized Krell dealer, distributor, or Krell if you have any
questions not addressed in this Owner’s Reference.
DTS Digital Surround ™ is a discrete 5.1 channel digital audio format available on CD, LD, and DVD soft-
ware which consequently cannot be decoded and played back inside most CD, LD, or DVD players. For this
reason, when DTS-encoded software is played back through the analog outputs of the CD, LD, or DVD play-
er, excessive noise will be exhibited. To avoid possible damage to the audio system, proper precautions
should be taken by the consumer if the analog outputs are connected directly to an amplification system. To
enjoy DTS Digital Surround ™ playback, an external 5.1 channel DTS Digital Surround ™ decoder system
must be connected to the digital output (S/PDIF, AES/EBU, or TosLink) of the CD, LD, or DVD player.
This product is manufactured in the United States of America. Krell ® is a registered trademark of Krell
Industries, Inc., and is restricted for use by Krell Industries, Inc., its subsidiaries, and authorized agents. Krell
Current Mode™ and Smart System Setup™ are trademarks of Krell Industries, Inc. “DTS”, “DTS Digital
Surround”, “DTS ES Extended Surround”, and “Neo:6” are registered trademarks of Digital Theater
Systems, Inc. TosLink is a trademark of Toshiba Corporation. Manufactured under license from Dolby
Laboratories. "Dolby," "Pro Logic," and the double-D symbol are trademarks of Dolby Laboratories.
Confidential Unpublished Works. Copyright 1992–1997 Dolby Laboratories, Inc. All rights reserved. THX is
a registered trademark of Lucasfilm, Ltd. Re-Equalization, Timbre Matching, and Decorrelation are trade-
marks of Lucasfilm, Ltd. All other trademarks and trade names are registered to their respective companies.
CONTACT
INFORMATION
WARNINGS
© 2002 by Krell Industries, Inc. All rights reserved P/N 305947