Krell Industries 7.1 - Manual (Page 75)

Operating the Home Theater Standard 7.1
Krell Home Theater Standard 7.1 71
After the Home Theater Standard 7.1 is connected to sources and
amplifiers, and the system is configured, the Home Theater Standard
7.1 is ready for operation.
1. Insert the AC power cord into the IEC connector (56) on the
Home Theater Standard 7.1. Insert the other end into the AC wall
receptacle.
2. Move the back panel power switch (55) into the up (on) position.
3. The red stand-by LED on the front panel illuminates. The words
PLEASE WAIT, INITIALIZING appear in the front panel display (25), fol-
lowed by the model name, software version, and the AC line fre-
quency. After 5 seconds the initializing message disappears, and
the front panel display becomes blank. The Home Theater
Standard 7.1 is ready to be powered on.
After five seconds of inactivity, the display becomes blank.
4. Use either the front panel power button (1) or the remote control
power pre key (58) to power on the Home Theater Standard 7.1.
The blue power LED (2) on the front panel illuminates. The Home
Theater Standard 7.1 is now in the operational mode.
5. To return to stand-by, press the front panel power button or
power pre key again.
Krell recommends that the back panel power switch remain up (on) at all
times
.
The Home Theater Standard 7.1 has a discrete tape input and out-
put. The tape output is used to send an input signal from any analog
input (S-1 through S-7, B-1, or VCR1) to a recording source or
processor. You can use the tape feature in three ways:
1. Use the tape input to playback pre-recorded tapes.
2. Use the tape input to compare the output signal of a three-head
analog tape recorder to the output signal of an audio source.
Press the tape button (14) or key (70) to switch between the tape
recorder output (LED illuminated) and the input source (LED not
illuminated).
Press and hold a device key for three seconds, after the device
has been selected, to change the tape output source bus to the
currently selected zone. Tape out can come from the main zone
or zone 2.
ON/OFF/STAND-BY
TAPE INPUT
AND OUTPUT
Note