Wire feed rolls and guide tubes, Operation – Lincoln Electric LN-8 SVM132-A User Manual
Page 29
B-5
OPERATION
B-5
WIRE FEED ROLLS AND GUIDE
TUBES
The drive rolls and guide tube kits are ordered sepa-
rately. Refer to Figure B.3 and install these parts per
the following instructions:
1. Loosen the idle roll spring pressure screw.
2. Remove the drive roll screw and clamping collar
from the drive shaft.
3. Install the drive roll and replace the clamping col-
lar. Tighten the drive roll screw.
4. Remove idle roll shaft screw. Install the idle roll
and idle roll shaft screw.
5. Remove the large ingoing guide from the rear
brass block by loosening the locking screw.
6. Loosen the ingoing guide tube clamping screw.
Install the ingoing guide tube (which is stenciled
“in”) through the rear brass block. Tighten the
clamping screw.
LN-8
FIGURE B.3 – WIRE FEED ROLLS AND GUIDE TUBE INSTALLATION
LOCKING
SCREW
OUTGOING
GUIDE TUBE
CLAMPING
COLLAR
DRIVE
ROLL
DRIVE
ROLL
SCREW
INGOING
GUIDE
TUBE
CLAMPING
SCREW
LOCKING
SCREW
LARGE
INGOING
GUIDE
IDLE ROLL
SPRING PRESSURE
SCREW
IDLE
ROLL
IDLE ROLL
SHAFT SCREW