Troubleshooting and repair, Wire drive assembly and component replacement – Lincoln Electric LN-8 SVM132-A User Manual

Page 87

Advertising
background image

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

F-37

TROUBLESHOOTING AND REPAIR

F-37

7. Disconnect two leads #567 (blue),

and lead #568 (blue) from the
shunt using the 11/32 in. wrench.
See Figure F.12. Note the lead
placement on the shunt for
reassembly.

8. Using a 7/16 in. wrench, loosen

the two hex head screws that
secure the reed switch bracket to

the front of the wire drive assem-
bly. Slide the bracket off the front
of the wire drive assembly.

9. Using an offset flat blade screw-

driver, remove the two mounting
screws below the shunt and the
one mounting screw below the
wire drive motor. Remove the wire
drive assembly through the wire
drive side of the case.

LN-8

WIRE DRIVE ASSEMBLY AND COMPONENT REPLACEMENT

(continued)

FIGURE F.12 – REED SWITCH REMOVAL AND SHUNT ELECTRICAL CONNECTIONS

SHUNT

#567

#568

REED

SWITCH

BRACKET

HEX HEAD

SCREWS

Advertising