Land Rover DEFENDER LT77S - Manual (Page 23)

MANUAL GEARBOX
MAINSHAFT GEAR END FLOAT CHECKS Third gear end-float.
1. Hold mainshaft in vice front end downwards.
2. Fit front circlip for first-second synchromesh.
3 . Fit second gear cone.
4. Fit spacer.
5. Fit snap ring.
1. Fit needle roller to third gear.
2. fit third gear bush to third gear.
3. Place gear on flat surface, bush flange
downwards, and with a straight edge across
gear check clearance between straight edge
and gear.
Not to exceed
M
Second gear end-float.
First gear bush end-float.
1. Fit needle roller and second gear
2. Fit third gear bush.
3 . Check clearance between second gear and
bush flange. Not
to exceed
4. Remove above components.
1. Invert mainshaft rear end uppermost.
2. Fit inner and outer second gear baulk rings.
'
OVERHAUL 19