Land Rover DEFENDER LT77S - Manual (Page 39)

BELL HOUSING
-
FOUR CYLINDER ENGINE
MANUAL GEARBOX
BELL HOUSING
-
V8 ENGINE
Fit bellhousing locating over hollow dowels and
secure with bolts.
1. Fit bell housing locating on hollow dowels.
NOTE: Fit the 12 x 45 bolts through
dowels and 12 x 30 bolts in
remaining positions.
2. Secure pivot post.
3. Apply molybdenum disulphide grease to pivot
post, lever pads and pins.
4. Assemble pads to lever and lever to bearing
and fit assembly to pivot post.
5. Fit staple to release assembly, short leg to
lever.
NOTE: The staple is an aid t o assembly
only which may become dislodged or
lost in service without detriment.
NOTE: Fit the 12 x bolts through
dowels and 12 x bolts in remaining
positions.
2. Apply molybdenum disulphide grease to pivot
post, release lever, socket and push
rod. Not
the bearing guide.
3. Fit 'C' washer to pivot post.
4. Fit spring clip to lever and fit lever to pivot post.
NOTE: Position spring clip behind 'C'
washer and tighten screw.
Fit bearing and retain with plastic staple.
4
4
4