Laser beta lasermike LS8000-3 - Manual (Page 98)

LaserSpeed 8000-3 Instruction Handbook
LaserTrak Software
Part No. 93463 / Drawing No. 0921-01561 Page 98 of 221 Revision A (Sep 2007)
The Communication screen will then be displayed showing the COM port and
BAUD rate and communication parameters it found to communicate with the
gauge.
Click the OK button to go to the Chart Recorder Screen. The
Chart Recorder screen will acquire Speed, Length, Quality Factor
and Status data from the LaserSpeed gauge and display it. The
Speed and Quality Factor will be displayed graphically and the
Length and Status information will be displayed in a table format.
Press the Start Readings button to acquire data from the gauge.
The Start Readings button will change to Stop Readings button.
Press the Stop Readings button to stop acquiring data from the
gauge. The graph, Graph Info and Gauge Status will only be
active when acquiring data from the gauge, and the Stop
Reading Button is being displayed. All the data will be frozen on
the Chart Recorder screen when the Stop Readings button is pressed and the
button changes back to Start Readings again.
Shows the COM Port and Settings
used to establish communication