Lucent Technologies AT&T 7400B - Manual (Page 110)

IMPORTANT INSTALLATION
SAFETY INSTRUCTIONS
WARNING
When this product is located in a separate building from the telephone communications system, a
line current protector MUST be installed at the entry/exit points of ALL buildings through which
the line passes.
The following are the ONLY acceptable devices for use in this application:
★ AT&T 4-type procetors
★ ITW LINX™ LP-type protectors
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
Use caution when installing or modifying telephone lines.
WARNING
RISK OF ELECTRIC SHOCK
EQUIPMENT MUST BE PROPERLY GROUNDED
Your AT&T equipment requires a properly grounded 3-prong AC power receptacle for safe
operation. Do not cut or remove the third (ground) prong from the AT&T power cord. Do not
use 2 wire extension cords or adapters to defeat the safety features of your equipment. If you
have a 2-prong receptacle, it is very important to have it replaced with a 3-prong receptacle,
installed by a qualified electrician.
Before equipment installation, a qualified technician should use an outlet tester or voltmeter to
check the AC receptacle for the presence of ground as shown in the figure below.