Lucent Technologies AT&T 7400B - Manual (Page 92)

APPENDIX D: QUICK-REFERENCE SUMMARIES DEFINITY Communications System
7400B Data Module
Page D-2 User’s Guide
Command Description
AT Command prefix—precedes most commands.
A Go off hook and remain in command state.
A/ Repeat the last command line.
D Enter originate mode and dial number that follows.
E0 Inhibit command state echo.
E1 Enable command state echo.
H0 Go on-hook (hang up).
H1 Accepted but causes no action.
I0 Returns decimal number 249 to data terminal.
I1 Returns ROM checksum as two 4-digit hexadecimal numbers.
I2 Returns OK.
O Return to on-line mode.
Q0 Enable display of result codes.
Q1 Disable display of result codes.
Sr Set pointer to S-register r.
Sr=n Set S-register r to value n.
Sr? Display value stored in S-register r.
V0 Display short form (numeric) result codes.
V1 Display verbose form (text) result codes.
X1 Enables features of result codes 0-4.
X2 Enables features of result codes 0-5, 10-12, 14.
X3 Enables features of result codes 0-6, 10-12, 14.
X4 Enables features of result codes 0-7, 10-12, 14.
Z0 Reset and recall stored configuration profile 0.
Z1 Reset and recall stored configuration profile 1.
(more)
TABLE D-1 AT COMMAND SET