Lucent Technologies AT&T 7400B - Manual (Page 88)

APPENDIX C: APPLICATION NOTES
DEFINITY Communications System
7400B Data Module
Page C-8
User’s Guide
CROSSTALK XVI Crosstalk XVI is a data communications software package produced by
Digital Communications Associates.
Configuring the Software
1. At the DOS prompt, type
xtalk [ Enter ]
A title screen is displayed for a few seconds, followed by the
Status Screen as shown below.
------- CROSSTALK - XVI Status Screen -------
I
NAme CROSSTALK defaults (Hayes 2400)
NUmber
LOaded STD
I
CApture Off
Communications parameters
------- Filter settings -------
--------- --------
I
I I
I
Full DEbug Off LFauto Off
SPeed 2400 PArity None DUplex
DAta 8 S T O P 1 EMulate None TAbex Off BLankex Off
POrt 1
MOde Call INfilter On OUtfiltr On
--------------- Key settings --------------
-----SEnd control settings ----
I I I
II
ATten Esc
SWitch Home
COmmand ETX (ˆC) CWait None
BReak End LWait None
------ ------- -------------- Available command files ---------------------------
I
1) AT&T
I
2) NEWUSER 3) SETUP 4) STD
2 . Choose the number next to the command file SETUP shown on
your Status screen or press the number for Setup and [ Enter ] again
to access the command line, then type LOad SETUP.
3.
4.
5 .
6 .
7 .
To continue the SETUP program press [ Enter ].
Select the letter next to Hayes Smartmodem (all models).
Select the letter next to Hayes Smartmodem 2400.
Select the COMmunication port to which your data module is
connected (typically COM 1).
Press [ Enter ], and then wait a few seconds as Crosstalk sets up the
7400B Data Module.