Shafts. see figure f.28, Small flathead screwdriver, Troubleshooting & repair – Lincoln Electric INVERTEC SVM158-A User Manual
Page 117
TROUBLESHOOTING & REPAIR
F-67
F-67
V350-PRO
ADVANCED PROCESS PANEL
REMOVAL AND REPLACEMENT (continued)
FIGURE F.28. – SCREW IN CAP
Small Flathead
Screwdriver
18. Replace the Advanced Process board.
19. Replace the two phillips head screws at the
bottom of the advanced process board.
20. Perform the Remote Board Replacement
21. Replace the 9/16” nuts and their washers
behind the “Adjust” and “Select” knobs.
22. Using a small screwdriver replace the two
knobs previously removed.
23. Replace the three 5/16” screws previously
removed from the front of the machine located
around the Advanced Process board.
24. Reconnect plug #J33 previously removed.
25. Replace the four phillips head screws removed
from the front of the machine located around
the two welder output terminals.
26. Replace the two flat head screws and their
washers from around the input power switch.
27. Using a 5/16” nut driver replace the two
screws previously removed from the bottom
front of the machine
28. Replace the case wraparound cover.