Line 6 3.7 User Manual
Page 51
Line 6 GearBox 3.7 – Driver Panel & Recording
3•7
effects, and a fully unprocessed signal.
Dual-Tone Source*: If you’ve selected one of the dual input configurations from the input menu,
•
Record 3-4 will always carry the signal from the second audio source. When GearBox is running,
these sends will carry the Tone 2 signal of a Dual-Tone configuration.
*Note: TonePort DI, GX and GuitarPort devices can only run in Single-Tone configuration.
POD X3 devices show a list of 5 Record Sends:
Note that the type of signal that is fed to each Send is configured on the POD X3’s on-board Outputs
- Studio/Direct Mix settings screen. Or, if GearBox is running, the Studio/Direct Mix Pan sliders and
Mute buttons for Tone 1 and Tone 2 as well as the Send volume knob all affect the signal fed to Send
1-2. To put it another way, Send 1-2 is fed the same “Studio/Direct Mix” as your main outputs, which
could be just a Tone 1, or some combination of Tone 1 & 2, depending on how you set the Studio/
Direct mix controls. Please refer to your
options and especially about POD X3’s unique Dual Tone operation.
POD X3 also offers a Monitor Level slider in this tab as well - you can use this to independently adjust
your POD X3 hardware monitor signal while recording (independently of the Send signal level that is
being recorded).