Line 6 3.7 - Manual (Page 74)

Line 6 GearBox 3.7 – GearBox Stand-Alone Application
4•4
For TonePort/GuitarPort devices – These controls affect the Monitor and playback signal paths for
both Record Sends 1-2 and 3-4, or both Tones when using a Dual-Tone Source.
For TonePort UX8 only – Note that GearBox’s record sends are labeled “9-10” and “11-12”.
9 - Bypass button:
TonePort – will bypass all amp and effects processing for the currently displayed Tone. Just your
“naked”, unprocessed signal will be heard as well as routed to your Record Sends when bypassed.
GuitarPort – will bypass all amp and effects processing. Just your “naked”, unprocessed signal will
be heard as well as routed to your Record Sends when bypassed.
PODxt – will bypass only the amp
10 - Tuner button: Toggles the display of the Guitar Tuner.
11&12 - Effects Show/Hide and On/Off toggles:
Clicking on the top portion of each of the little “stomp box” icons in this row will toggle the •
lower Effects Panel to display that effect’s controls. You can do this independently of switching
the effect itself On/Off. Note that you can use your left or right mouse button to do this.
Clicking the bottom portion of the stomp box will toggle the effect On and Off.
•
13 - GearBox Record Send and VU Meters:
TonePort & GuitarPort – These show the signal level of the GearBox-processed audio that is
sent to your recording software. For UX8, this send is labeled Send 9-10. For other TonePorts, it’s
labeled Send 1-2. This send represents the fully-processed GearBox audio signal. To record exactly
what you hear, select this send as your audio input, within your recording application. If the little
clip indicator at the bottom of each meter lights red, turn down the RECORD knob and/or turn
off the +18 button, because you are clipping your audio, which can cause harsh, bad sound for your
recording.
These indicators will light up red when
the signal is clipping.
Note – GearBox will not display VU Meters when a PODxt is the source device.
14 - Record Send 1-2 controls:
Record knob – • controls the level of your GearBox processed Tone that is routed to Record Send
1-2. this will ultimately control the record level into your audio software for any track receiving
this Send 1-2 signal.