Line 6 3.7 - Manual (Page 93)

Line 6 GearBox 3.7 – GearBox with POD X3
5•8
POD X3 Live Pedal Control Options
Pedal Control
Pedal Assignment for Tone 1 & Tone 2
Tone 1 COMP button assign (POD X3 Live)
Tone 1 FX LOOP button assign (POD X3)
Tweak parameter assignment for
Pedal 1 & Pedal 2
Tone 2 COMP button assign (POD X3 Live)
Tone 2 FX LOOP button assign (POD X3)
Pedal Control – Choose here to have the pedal affect either Tone 1, Tone 2 or Both.
Pedal Assignment – Choose what set of features you want the pedal(s) to control specifically for
each Tone 1 and Tone 2. The pedal built-in a POD X3 Live and FBV foot controllers is pedal “1”,
and the optional external pedal that you can connect to it is pedal “2”. (On the large FBV unit
with two on-board pedals, the left pedal is Pedal “1” and the right is Pedal “2”). Note that you can
independently set your Pedal Assignments in the top “1” slot to control Tone 1 effects, and in the
“2” slot to control Tone 2 effects (or you can set them the same). The selectable options in each of
these two slots are:
1=W/V|2=Vol • – Pedal 1 controls Wah with the toe switch controlling Wah on/off. When
the Wah is “off” then Pedal 1 controls Volume. Pedal 2, if present, controls Volume.
1=Twk|2=Vol
• – Pedal 1 controls whatever is assigned in the Tweak selector below. Pedal
2, if present, controls Volume.
1=W/V|2=Tw
• – Pedal 1 controls Wah with the toe switch controlling Wah on/off. When
the Wah is “off” then Pedal 1 controls Volume. Pedal 2, if present, controls Tweak, assigned
in the selector below.
Pedal 1 & 2 Tweak – If you’ve assigned Pedal 1 and/or Pedal 2 to control “Tweak” (in either of
the above Pedal Assignment selectors), this is where you pick the effect parameter that will be
controlled. The list of available settings is too long to list here - click the menus and see what you
find!
Tone 1 & Tone 2 Footswitch Assign - In these slots you can choose which Tone 1 and Tone 2
effect blocks are toggled on/off by the (POD X3 Live) COMP button or (FBV foot controller with
POD X3/X3 Pro) “FX LOOP” button.
For POD X3 Live: • These settings determine what feature the on-board COMP (BOOST)
footswitch will control for each Tone 1 and Tone 2. The options are Compressor, Amp, FX
Loop and Reverb.
For POD X3/X3 Pro:
• This setting determines what feature the FX LOOP footswitch on
a FBV will control. The options are Compressor, Amp or Dual (equivalent to the POD X3
“TONE 2/Hold For Dual button”).