Line 6 3.7 - Manual (Page 77)

Line 6 GearBox 3.7 – GearBox Stand-Alone Application
4•7
GearBox!
Note: TonePort DI, GX and GuitarPort can only run in Single-Tone configuration.
Pre/Post Record Send
GearBox displays an additional Record Send for TonePort and GuitarPort devices, which provides
several useful signal routing functions. When you have a single input Source chosen in the Source
Select menu, you’ll see the Send 3-4 icon (labeled Send 11-12 for UX8) in the row of the Effects
icons.
Click on this Send icon to show its controls in the panel below.
Select PRE to route an
unprocessed signal to Send 3-4.
Select POST to route a semi-
processed signal to Send 3-4
(see below).
Record Send 3-4 has its own dedicated set of controls and meters that are equivalent in function to
the Send 1-2 controls of the same name (see the GearBox Controls and Operations section)*. When
using an audio recording software configured to use the ASIO driver (on Windows ® ) or Core Audio
driver (on Mac ® ), it is possible to select the GearBox Send 1-2 or Send 3-4 independently for your
track inputs for recording.
Please note that the pre/post setting of Record Send 3-4 is not saved within the Tone Preset.
* For TonePort UX8 only – With a UX8, Record Send 9-10 is the primary GearBox-processed Send,
and Record Send 11-12 is the pre/post switchable Send.
Note – if your audio application is configured to use the WDM/DirectSound driver (on Windows ® ), you
will only be able to access Send 1-2 in the recording software, and it will carry both GearBox Send 1-2
and 3-4 signal paths, pre-mixed into Send 1-2.
Monitoring a GearBox-processed Tone While Recording “Dry”
With GearBox Send 3-4, you can send a dry, unprocessed signal to your favorite recording application,
while monitoring a fully GearBox-processed tone thru your hardware’s outputs*. The Send’s Pre/Post
switch gives you a couple of options: