Lincoln Electric POWER FEED 10M SINGLE/DUAL SVM172-A - Manual (Page 115)

POWER FEED 10M SINGLE/DUAL
TROUBLESHOOTING & REPAIR
F-11 F-11
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Observe all Safety Guidelines detailed throughout this manual
Error Codes for the Power Wave 455: Code 10555 and below
Note: For any Err # listed below write down the error number for reference and try cycling power to see if the
error clears itself. If not, refer to the What to Do column for the given Err.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con-
tact the Lincoln Electric Service Department at 1-888-935-3877 for electrical troubleshooting assistance before
you proceed.
CAUTION
PROBLEMS
(SYMPTOMS)
POSSIBLE CAUSE
RECOMMENDED
COURSE OF ACTION
Display shows any of the following:
Err 001
Err 003
Err 004
Err 005
Err 006
More than 1 CB with the same
group number.
Too many objects in group.
More than 1 object of the same
equipment type with the same group
# and feed head #.
A feed head has its feed head dip
switches set to zero in a group with
more than one object.
Did not receive a recognition com-
mand from the power source.
Make sure the group dip switch set-
ting is unique for each CB.
A given group can only support up
to 7 objects. Remove any objects
over 7 from the group either by
changing the group dip switch set-
tings or physically disconnecting any
objects over 7 in the group.
Adjust the dip switch setting to make
either the group # or feed head #
unique for all objects of the same
equipment type.
The appropriate feed head # is 1
through 7. Check the dip switch set-
ting chart in INSTALLATION section
and set the switches to make the
Feed head ID non-zero.
Check to see if the status light is not
solid green on the power source
(refer to status light states in OPER-
ATION section if not). Also, check
continuity in the communication lines
from CB to Power Source (refer to
wiring diagram). Refer to Power
source trouble shooting section for
additional information. If all these
avenues fail, replace CB mother PC
board.