Lincoln Electric POWER FEED 10M SINGLE/DUAL SVM172-A - Manual (Page 79)

POWER FEED 10M SINGLE/DUAL
OPERATION
P.99 Show Test Modes
Many weld tables include special modes for testing
and servicing the welding system. Set this parameter
to YES to show all test modes.
When the power source is turned off, the Show Test
Modes parameter automatically reverts back to "NO".
P.100 View Diagnostics
Diagnostics are only used for servicing the Power
Wave system.
Yes = Shows P.101 through P.500 in the SETUP
menu.
No = Only P.0 through P.100 are shown in the SETUP
menu.
P.101 Event Logs
Press the right MSP4 button to view the Event Logs.
Rotate the encoder to select the object to read and
then press the right MSP4 button. Various software
information will appear about key system events.
Press the left MSP4 button to exit.
P.102 Fatal Logs
Press the right MSP4 button to view the Fatal Logs.
Rotate the encoder to select the module to read and
then press the right MSP4 button. Various software
information will appear about critical module actions.
Press the left MSP4 button to exit.
P.103 Software Version
Press the right MSP4 button to view the software
loaded into each module (p.c. board). Rotate the
encoder to select the module to read and then press
the right MSP4 button. The panel will display the
main software version loaded into the module. Press
the left MSP4 button to exit.
P.104 Hardware Version
Press the right MSP4 button to view the hardware ver-
sion of each module (p.c. board). Rotate the encoder
to select the module to read and then press the right
MSP4 button. The panel will display the main hard-
ware version loaded into the module. Press the left
MSP4 button to exit.
P.105 Welding Software
Press the right MSP4 button to view the welding soft-
ware version inside the power source. Press the left
MSP4 button to exit.
P.106 Ethernet IP Address
Press the right MSP4 button to view the IP address of
the Ethernet board. If no Ethernet Board is installed,
the display shows "No Enet Found." Press the left
MSP4 button to exit.
P.107 Power Source
Press the right MSP4 button to view the type of power
source connected to the control box. Press the left
MSP4 button to exit.
BB-11 BB-11
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C