Lincoln Electric POWER FEED 10M SINGLE/DUAL SVM172-A - Manual (Page 9)

A-3 A-3
POWER FEED 10M SINGLE/DUAL Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
INSTALLATION
SAFETY PRECAUTION
LOCATION
• The Power Feed 10M Single Wire Feeder has an
IP21 rating, suitable for indoor use.
• The Power Feed 10M Single Wire Feeder should be
operated in a substantially upright position.
• Do not submerge the Power Feed 10M Single Wire
Feeder.
• The Power Feed 10M Single Wire Feeder is not suit-
able for stacking.
Locate the Power Feed 10M Single Wire Feeder away
from radio controlled machinery. The normal operation
of the Power Feed 10M Single Wire Feeder may
adversely affect the operation of RF controlled equip-
ment, which may result in bodily injury or damage to
the equipment.
ELECTRIC SHOCK can kill.
• Only qualified personnel should
perform this installation.
• Turn off the input power to the
power source at the disconnect
switch or fuse box before working
on this equipment. Turn off the
input power to any other equipment
connected to the welding system at
the disconnect switch or fuse box
before working on this equipment.
• Do not touch electrically hot parts.
----------------------------------------------------------------------------------------
FIGURE A.1
FIGURE A.2
MOUNTING
Wire Drive Mounting (See Figure A.1)
The wire drive may be mounted by using the four holes
on the bottom. Because the feed plate and gearbox are
electrically "hot" when welding, make certain the parts
do not contact the any structure or person.
Mount the wire drive with the drive rolls in the vertical
plane to prevent dirt from collecting in the wire drive.
Angle the drive and feed plate to prevent sharp bends
in the gun and cable and incoming wire.
Control Box Mounting (See Figure A.2)
Boom model Power Feed 10M Single Wire Feeder's
feature a control box that mounts separately from the
wire drive.
The back of the control box has four keyhole slots for
mounting. #10 screws are recommended for mounting.