Lincoln Electric POWER FEED 10M SINGLE/DUAL SVM172-A - Manual (Page 26)

OPERATION
POWER FEED 10M SINGLE/DUAL
B-4 B-4
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
PROCESS LIMITATIONS
The Power Feed 10M Single Wire Feeder is not suit-
able for:
• SAW
• GTAW with HF
The MSP4 does not support "Spot" welding.
Not all weld modes or processes described in this manual are avail-
able on all Power Wave power sources.
REQUIRED EQUIPMENT
Lincoln’s Power Feed 10M Single Wire Feeder is
designed for use with the Power Wave family of power
sources. These include:
• Power Wave 355 • Power Wave 455M CE
• Power Wave 455 • Power Wave 455M STT
• Power Feed 455/STT • Power Wave 455M STT CE
• Power Wave 455M
• Power Wave 655
ADDITIONAL REQUIRED EQUIPMENT
• Drive Roll Kits
• Control Cables
• Gun and Cable Assembly
• Weld Wire
• Shielding gas
• Work Cable and Clamp
EQUIPMENT LIMITATIONS
• The Power Feed 10M Single Wire Feeder does not
operate with the Power Wave 450.
• The Power Feed 10M Single Wire Feeder does not
operate with any analog based power sources (CV-
xxx machines, DC-xxx machines, etc.)
• The Memory Panel is required to set procedure limits.
• The Boom model does not support push-pull guns or
GTAW welding.
• A push-pull gun and foot amptrol may not be plugged
into the Power Feed 10M Single Wire Feeder at the
same time.