Lincoln Electric POWER FEED 10M SINGLE/DUAL SVM172-A - Manual (Page 71)

POWER FEED 10M SINGLE/DUAL
OPERATION
BB-3 BB-3
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Se
ct
io
n
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C
Re
tu
rn
to
Ma
st
e
r
T
O
C PRODUCT DESCRIPTION
The Power Feed 10M Dual Wire Feeder unit consists
of a user interface and two wire drives. This unit will be
available as a bench model or a boom model.
The Power Feed 10M Dual Wire Feeder is a high per-
formance, digitally controlled, modular wire feeder.
Properly equipped, it can support the GMAW, GMAW-
P, FCAW, SMAW, GTAW, and STT processes. The
Power Feed 10M Dual Wire Feeder is designed to be
a part of a modular, multi process welding system. The
Power Feed 10M Dual Wire Feeder is a Semi-
Automatic unit that is designed to interface with the
Power Wave M family of welding machines. It consists
of a user interface (UI) and wire drive (WD) that oper-
ate on 40VDC input power. The user interface is
designed to act as a means to access the functionality
(weld mode, run-in, volts, current etc.) of the welding
system. The wire drive unit is a 4 driven roll feeder that
can "push" various types of welding wire.
Each component in the system has special circuitry to
"talk with" the other system components, so each com-
ponent (power source, wire feeder, electrical acces-
sories) knows what the other is doing at all times. This
shared information lays the groundwork for a system
with superior welding performance.
DUAL HEAD UNIT
Two Control PC boards: one board supports user inter-
face and wire drive functions and second board sup-
ports second wire drive functions.
RECOMMENDED PROCESSES AND
EQUIPMENT
RECOMMENDED PROCESSES
The Power Feed 10M Dual Wire Feeder can be set up
in a number of configurations. They are designed to be
used for GMAW, GMAW-P, FCAW and STT processes
for a variety of materials, including mild steel, stainless
steel, and cored wires. Other processes such as STT,
SMAW and GTAW can be controlled using the user
interface portion of the unit. (See Accessories Section
for Part numbers and connections.
RECOMMENDED EQUIPMENT
The Power Feed 10M Dual Wire Feeder must be used
with communication compatible welding equipment.
That is, the communication protocol that is used in the
welding system must be capable of communicating
with the wire feeder. This would be any power source
that has the Arclink receptacle available and is oper-
ating with LincNet or Arclink software.