Panasonic WJ-HD200 - Manual (Page 26)

26
● Recording Mode Setup PROG “1-4”
NO. “1-4” SETUP
Parameters for internal timer recording are assigned to
each event (NO. 1-4) of the program (PROGRAM 1-4) in
this menu. There are five recording modes available: super
fine (SF), fine (FQ), normal (NQ), long-time (EX) and option-
al (SP). If combined with audio recording (-A), the number
of recording modes doubles. The selected recording mode
determines the remaining recording time that is displayed
on the monitor.
In the SP mode, the field rate and picture quality are vari-
able, and can be selected at option in the range of 0.1 to
30 FPS and quality levels from five options respectively.
After the recording mode is selected, the available record-
ing time is determined and displayed.
Notes:
• For the recording modes other than SP, suffixed
“xxx” in the table will be replaced by a calculated
recording time of 24, 48, 72, 96, 120, 170, 180, 240,
480, 960, 1 200, 1 440, 2 160, 2 880, or 8 640
hours. The selected recording mode with the preset
rate and quality will determine the suffix.
• Actual recording rate even preset to 30 or 15 FPS
may be lessened to 7.5 FPS at worst, while such
busy multi task as playback, remote-access play-
back, remote-access live image, FTP access, multi
split display, video motion detection are carried out
at a time. The status display will indicate as “*PLAY”
while playing back the images recorded with a
changed rate from the preset.
• Suffix “xxx” following “SP-“ is specified in REC
MODE TABLE in ADDENDUM attached to the man-
ual.
1. Move the cursor to MODE, and press the JogDial. The
mode area will be highlighted.
2. Select a recording mode using the JogDial, and press
the Jogdial. Audio data will be recorded when a mode
with hyphen A is selected.
Available Recording Mode: SF, FQ, NQ, EX, SP, SF-A,
FQ-A, NQ-A, EX-A, and SP-A.
N/A
Rec Mode Quality Audio Record Note
SF-xxxH Super Fine N/A
Field rate, quality
selected optionally
Field rate, quality
selected optionally
N/A
N/A
N/A
Available
Available
Available
Available
Fine
Normal
Long time
Optional setup
Super Fine
Fine
Normal
Long time
FQ-xxxH
NQ-xxxH
EX-xxxH
SP-xxxH
Available Optional setup SP-AxxxH
SF-AxxxH
FQ-AxxxH
NQ-AxxxH
EX-AxxxH
3. When SP or SP-A is selected, specify a recording rate
(REC RATE) using the JogDial, and press the JogDial.
Available recording rate: From 0.1 to 30 FPS
4. When SP or SP-A is selected, specify a recording quali-
ty (REC QUALITY) using the JogDial, and press the
JogDial.
Available recording quality: SUPER FINE, FINE, NOR-
MAL, EXTENDED
● Alarm Recording Mode Setup ALM
REC MODE
Alarm events arising within the time zone specified by the
program will start recording with the preset parameters.
Refer to “PROG NO. SETUP” described above in this menu
for operating procedures, and available parameters, since
they are very much similar.
● Pre-alarm Recording PRE ALM REC
Picture recording will start prior to the alarm activation at
the time specified by this setting.
1. Move the cursor to PRE ALARM REC with the [D] or
[C] button.
2. Select the desired pre-recording time with the JogDial,
and press the JogDial.
The default is 0S.
Available time (seconds): 0S, 1S, 2S, 3S, 4S, and 5S