Alarm recording mode setup alm rec mode, Pre-alarm recording pre alm rec, Post-alarm recording post alm rec – Panasonic WJ-HD200 User Manual
Page 58: Dynamic recording dynamic rec, Trigger action setup trigger action setup, Camera recording setup cam rec setup
59
at a time. The status display will indicate as
“*
→
PLAY” while playing back the images record-
ed with a changed rate from the preset.
• Suffix “xxx” following “SP-“ is specified in REC
MODE TABLE in ADDENDUM attached to the man-
ual.
1. Select a recording mode. Audio data will be recorded
when a mode with hyphen A is selected.
Available Recording Mode:
SF, FQ, NQ, EX, SP, SF-A,
FQ-A, NQ-A, EX-A, and SP-A.
2. When SP or SP-A is selected, specify a recording rate
(REC RATE).
Available Recording Rate:
From 0.1 to 30 FPS
3. When SP or SP-A is selected, specify a recording quali-
ty (REC QUALITY).
Available recording quality:
SUPER FINE, FINE, NOR-
MAL, EXTENDED
●
Alarm Recording Mode Setup ALM
REC MODE
Alarm events arising within the time zone specified by the
program will start recording with the preset parameters.
Refer to “PROG NO. SETUP” described above for operating
procedures, and available parameters, since they are very
much similar.
●
Pre-alarm Recording PRE ALM REC
Available Time (seconds):
0S, 1S, 2S, 3S, 4S, and 5S
●
Post-alarm Recording POST ALM
REC
Available Time (Second):
5, 10, 20, 30
Available Time (Minute):
1, 1.5, 2, 3, 6
Manual:
Recording continues until the [REC STOP] but-
ton is pressed, or RESET IN signal is supplied to the
rear panel.
Continue
:Recording continues while the alarm input is
active, or at least for 10 seconds if the input early
turns inactive.
●
Dynamic Recording DYNAMIC REC
ALM-MULTI:
Alarm activated channels are recorder
with priority over others.
OFF:
All channels are evenly recorded.
■
Trigger Action Setup TRIGGER
ACTION SETUP
8
Mode (MODE)
OFF:
Disables alarm recording, logging, or warning.
REC&ALARM:
Enables all alarm recording, logging
and warning.
REC:
Enables alarm recording and logging, but dis-
ables warning.
Click the [SET] button if all are adequately set.
■
Camera Recording Setup CAM
REC SETUP
Click the CAMERA REC SETUP in the system setup
window to open the menu.
This menu is provided for the purpose of disk space
saving. Each camera channel can be recorded only
when an alarm operates while it will not be recorded
during non-alarm status.
ALARM-ONLY:
Records the camera channel only
when the alarm operates.