Panasonic WJ-HD200 - Manual (Page 39)

39
● IP Address IP ADDRESS
The default is “192.168.000.010”.
● Netmask NETMASK
The default is “255.255.255.000”.
● Gateway GATEWAY
The default is “192.168.000.001”.
■ Switcher Setup SWITCHER
SETUP
Video switcher functions are programmed in this menu
setup.
● Start Display START DISPLAY
The image in the selected form will be displayed on the
monitor when the recorder is turned on.
Single Image: CH 1 to CH 8
Quad Image: QUAD-4A (including 1-4), QUAD-4B
(including 5-8)
Multi Image: 9SCREEN (including 1-8)
Sequence: SPOT SEQ, MULTI SEQ
● Multiscreen Selection MULTI SEL
MODE
When the [MULTI SCREEN SEL] button on the front panel is
pressed, the monitor display will change as follows
depending on the selection.
QUAD ONLY: QUAD-4A
→
QUAD-4B
→
QUAD-4A
ALL: QUAD-4A
→
QUAD-4B
→
9SCREEN
→
QUAD-4A
● Sequence Setup SEQUENCE SETUP
1. Move the cursor to SEQ SETUP in the SWITCHER
SETUP menu, and press the JogDial.
The SEQ SETUP menu opens.
2. Select either MULTI SEQ SETUP or SPOT SEQ SETUP
with the [D] or [C] button, and press the JogDial. The
selected menu opens.
● Multiscreen Sequence Setup MULTI
SEQ SETUP
Open the QUAD SEQ SETUP menu to program the
sequence steps for displaying quad-split and single input
images.
1. Move the cursor to the desired step using the [D] or
[C] button.
2. Select a camera number with the JogDial, and press
the JogDial.
The default camera number is identical to the step num-
ber.
Available camera: From 1 to 8 individually, 4A(1-4), or
4B(5-8)
Note: The recorder will skip the step you assigned “–”.
3. Select duration for the step with the JogDial, and press
the JogDial.
Available duration: 2-30 S
SWITCHER SETUP
START DISPLAY QUAD-4A
MULTI SEL MODE ALL
SEQUENCE SETUP
O
CAMERA VIEW SETUP
O
SEQUENCE SETUP
MULTI SEQ SETUP
O
SEQUENCE TIMING INT
AUTO SKIP ON
SPOT SEQ SETUP
O
SEQUENCE TIMING INT
AUTO SKIP ON
MULTI SEQ SETUP
STEP CAM SEC
1
→
QUAD-4A 2S
2
→
QUAD-4B 2S
3
→
- 2S
4
→
- 2S
5
→
- 2S
6
→
- 2S
7
→
- 2S
8
→
- 2S