Panasonic WJ-HD200 - Manual (Page 27)

27
● Post-alarm Recording POST ALM
REC
This setting specifies the duration of alarm recording after
an alarm input. Functions active during alarm recording are
buzzer beeping, ALARM LED indication, "ALARM" status
display, and the ALARM OUT signal.
1. Move the cursor to POST ALARM REC with the [D] or
[C] button.
2. Select the desired duration with the JogDial.
The default value is 10 seconds.
The unit will revert to the previous status when the time
has elapsed.
Available Time (Second): 5, 10, 20, 30
Available Time (Minute): 1, 1.5, 2, 3, 6
Continue: Recording continues until the [REC STOP]
button is pressed, or RESET IN signal is supplied to
the rear panel.
Manual :Recording continues while the alarm input is
active, or at least for 10 seconds if the input early
turns inactive.
● Dynamic Recording DYNAMIC REC
This setting specifies recording pattern on the disk when
one or more alarm operate.
1. Move the cursor to DYNAMIC REC with the [D] or [C]
button.
2. Select the parameter with the JogDial, and press the
Jogdial.
The default is OFF.
ALM-MULTI: Alarm activated channels are recorded
with priority over others.
OFF: All channels are evenly recorded.
● Trigger Action Setup TRIGGER
ACTION SETUP
This setting specifies two roles of the alarm recording and
alarm control functions (Refer to page 44) in the post-alarm
sequence.
1. Move the cursor to TRIGGER ACTION SETUP O, and
press the JogDial.
The TRIGGER ACTION SETUP menu opens.
2. Move the cursor to the channel.
3. Select the parameter with the JogDial, and press the
Jogdial.
The default is REC&ALM.
OFF: Disables alarm recording or warning.
REC&ALM: Enables both alarm recording and warning.
REC: Enables alarm recording, but disables warning.
4. Repeat steps 2 and 3 until all channels are set.
5. Press the [SETUP/ESC] button to return to the PROG
“1” NO. “1” SETUP menu.
● Camera Recording Setup CAM REC
SETUP
This setting is provided for the purpose of disk space sav-
ing. Setting allows each camera channel to be enrolled in
all recording modes or exclusively in alarm recording.
1. Move the cursor to CAM REC SETUP, and press the
[SET] button. The CAM REC SETUP menu opens.
2. Move the cursor to the camera channel with the [D] or
[C] button.
3. Select the parameter with the JogDial, and press the
JogDial.
The default is REC.
REC: The channel is recorded in alarm recording, timer
recording and manual recording mode.
ALM-ONLY: The channel is recorded only when the
alarm operates.
4. Repeat steps 2 and 3 until all channels are set.
5. Press the [SETUP/ESC] button to return to the PROG
“1” NO. “1” SETUP menu.
CAM REC SETUP
CAM MODE
1 REC
2 REC
3 REC
4 ALM-ONLY
5 REC
6 ALM-ONLY
7 REC
8 REC
TRIGGER ACTION SETUP
CAM MODE
1 OFF
2 OFF
3 OFF
4 REC&ALM
5 REC
6 OFF
7 OFF
8 OFF