Phonetics IMS-4000 - Manual (Page 120)

IMS-4000 Manual
120
Figure 1: 4820 with Cable exiting through back of enclosure
Hidden cable surface installation
Bring the RJ-45 cable through the wall at the mounting location. Remove the sensor cover by turn-
ing the two hex screws on the bottom of the sensor housing clockwise. Bring the cable through
the back of the sensor and hold the sensor housing against the wall. Use a pencil to mark the hole
locations at the top and bottom of the housing. Remove the sensor from the wall. Install the drywall
anchors (if necessary) to the wall. vBring the cable through the back of the sensor and connect it
to the jack as shown in Figure 1. Attach the sensor to the wall using #6 tapping screws. Secure the
sensor cover by turning the two hex screws on the bottom of the cover counterclockwise.
Visible cable surface installation
Remove the sensor cover by turning the two hex screws on the bottom of the sensor housing clock-
wise. Hold the sensor housing against the wall. Use a pencil to mark the hole locations at the top
and bottom of the housing. Install the drywall anchors (if necessary) to the wall. Attach the sensor
to the wall using #6 tapping screws. Connect the cable to the jack as shown in Figure 2. Secure the
sensor cover by turning the two hex screws on the bottom of the cover counterclockwise.
Figure 2: 4820 with Cable exiting out enclosure bottom