Phonetics IMS-4000 - Manual (Page 49)

Figure 15: Node Network Settings
NOTE: If the Modify button is grey (inactive) then the unit either does not have the Allow
Remote Configuration option set, or the unit’s firmware does not support this feature and
requires upgrading.
Enter the new network parameters and click OK. The Node will reboot and temporarily disconnect
from the Host.
Configuring Environmental Inputs
Each host or node can have up to 8 external sensors connected. The host or node will automatically
identify what sensor type is connected to each input. To program the environmental input param-
eters expand the host or node tree by clicking the plus box next to the host/node name.
Channel Setup
Next, click in the plus box beside Environmentals to expand the tree below it. Choose the input you
would like to configure and right-click on the sensor name.
Figure 16: Environmental Input Channels
The Channel Setup screen will appear.
Chapter 2: Software
49