Panasonic AJ-HD3000 - Manual (Page 124)

– 124 –
INTERFACE SET UP menu
Key
F7
F8
F9
F10
F11
F12–F13
Key designation
PREREAD ° 1
For setting pre-read from
the remote commands.
EXIT
UB PRESET
For setting the UB preset
from remote.
VAR LIMT ° 2
V. LEV. CNT
——
Description
The setting can be changed by pressing the F7 key while holding
down the F key.
VIDEO: Video pre-read can be set.
AUDIO: Audio pre-read can be set.
V&A:
Both video and audio pre-read can be set.
Returns the VTR to the SET UP menu screen.
Selects the setting destination for the TCG UB preset command
supplied from the external source (RS-422/232C).
L&V: Sets the destination for LTC UB and VITC UB.
LTC: Sets the destination for LTC UB only.
VITC: Sets the destination for VITC UB only.
Selects the limit speed for the VAR command supplied from the
external source (RS-422/232C).
This item can be set by pressing the F10 key and F key together.
ON:
The tape speed is limited to the range from j 1x to i 2x
normal speed.
OFF: The tape speed is limited to the range from j 1.5x to
i 2.5x normal speed. (At speed above 2x or so or below
j 1x, pictures are searched without AT ON TRACK.)
Selects whether to vary the VTR HD/SD output in response to an
external video component adjustment command (RS-422, V/A
controller).
NORMAL: Identifies HD/SD commands and varies the level of
each.
HD: Varies HD output level forcibly.
SD: Varies SD output level forcibly.
BOTH: Varies This is varied in tandem with the HD
output/SD output level.
° 1 This item appears only when an SD format (525/59i or 625/50i) is used as the system format.
° 2 O Note N
° 2 Set this item to OFF for slow editing with the unit connected to an editing controller (such as the BVE-9100).
Phase synchronization may not be possible with slow editing near the
j 1 t or i 2 t speed.