Panasonic AJ-HD3000 - Manual (Page 77)

– 77 –
TC/CHR menu
∑ Changing the superimposing position
(1) Move the position using the cursor keys.
≥ When a cursor key is held down, the cursor will move more
quickly.
≥ When the center cursor key is pressed, the superimposing re-
turns to its initial position.
Center cursor key
Cursor keys
∑ Time code displays and VTR’s operating modes
Display the time codes and VTR’s operating modes as required.
Time code displays
CTL1: Control signal 1
TCG: Value generated by time code generator
CTL2: Control signal 2 LUBG: Value of LTC user bit generated
LTCR: LTC time code readout value VUBG: Value of VITC user bit generated
LUBR: LTC user bit readout value EXTC: External time code value
VTCR: VITC time code readout value EXUB: External user bit value
VUBR: VITC user bit readout value
≥ The colon (“:”) between the seconds and frames denotes the readout mode of the time code
reader.
Hours Minutes Seconds Frames
; ; ; ;
<
Blinking display: Time code cannot be read out.
[. ]: DF mode ON
[: ]: DF mode OFF
[ ]: First field
[. ]: Second field
[: ]: Time code can be read out or TCG value is displayed.
[ ]: Time code cannot be read out.
This indicates that the time code is the original time code which was recorded on the tape.
If the time code displayed is not accompanied by this cassette mark, it means that the time
code is the post-conversion time code. (This display will go off when setting the CTL or UB.)