Panasonic AJ-HD3000 - Manual (Page 185)

– 185 –
DIAG error messages
Message
OVER-RUN ERROR IN
RECEIVED COMMAND
FROM RS-422 PORT
RS-422 COMMUNICATION
STOP BY TIME OUT
RECEIVED INVALID
COMMAND FROM RS-232C
PORT
SUM-CHECK ERROR IN
RECEIVED COMMAND
FROM RS-232C PORT
PARITY ERROR IN
RECEIVED COMMAND
FROM RS-232C PORT
FRAMING ERROR IN
RECEIVED COMMAND
FROM RS-232C PORT
OVER-RUN ERROR IN
RECEIVED COMMAND
FROM RS-232C PORT
RS-232C COMMUNICATION
STOP BY TIME OUT
RECEIVED INVALID
COMMAND FROM
VA_CONT PORT
SUM-CHECK ERROR IN
RECEIVED COMMAND
FROM VA_CONT PORT
PARITY ERROR IN
RECEIVED COMMAND
FROM VA_CONT PORT
FRAMING ERROR IN
RECEIVED COMMAND
FROM VA_CONT PORT
OVER-RUN ERROR IN
RECEIVED COMMAND
FROM VA_CONT PORT
EXT LTC NOT READ
EXT VITC NOT READ
LTC IN TAPE NOT READ
IC CARD LOW BATTERY
Error description
An overrun error has occurred in the received
command.
A timeout error has occurred.
An undefined command has been received.
A sum check error has occurred in the received
command.
A parity error has occurred in the received
command.
A framing error has occurred in the received
command.
An overrun error has occurred in the received
command.
A timeout error has occurred.
An undefined command has been received.
A sum check error has occurred in the received
command.
A parity error has occurred in the received
command.
A framing error has occurred in the received
command.
An overrun error has occurred in the received
command.
There is a problem with the EXT TC input.
There is a problem with the EXT VITC input.
The LTC signal is not played back.
The IC card battery has a low remaining charge.
Replace the card.
On-screen display
RS-422 ERROR
RS-422 ERROR
RS-232C ERROR
RS-232C ERROR
RS-232C ERROR
RS-232C ERROR
RS-232C ERROR
RS-232C ERROR
VA-CONT ERROR
VA-CONT ERROR
VA-CONT ERROR
VA-CONT ERROR
VA-CONT ERROR
TC ERROR
TC ERROR
TC ERROR
CARD LOW BATT