Panasonic AJ-HD3000 - Manual (Page 16)

– 16 –
HOME menu
∑ Pre-read editing [Performed in the SD mode (480/59i or 576/50i) only.]
(1) Set the pre-read function to ON by pressing the F key and F11 key (PREAD A) or F12 key
(PREAD V) together.
(2) Perform the connections for pre-read editing as shown in the figure below.
(3) Proceed with pre-read editing in the desired insert editing mode.
(4) Restore the original connections upon completion of the editing.
(5) Press the F11 or F12 key to set the pre-read function to OFF.
(6) Check that there are no loop connections.
O Note N
During pre-read operations, the SD SDI MONITOR and AUDIO MONITOR connectors function
as monitoring connectors, and the input signals are output from the IN point to the OUT point in
their original state.
Further, the preread monitor function will not work when the monitor MIX function has been set
to ON. To use the function, set MIX to OFF.
PREAD V
ON
PREAD A
ON
Connections for pre-read editing
~ AC IN
CH 1 CH 2 CH 3 CH 4 CUE
UE
L R
H 1
SIGNAL GND
PUSH H 2 PUSH H 3 PUSH H 4 PUSH PUSH N PUSH OUT
OUTPUT CH CH CH CH
INPUT CH CH CH CH
HD
HD
REMOTE IN
ON
OFF
1 2 3
(SUPER)
(SUPER)
IN IN OUT
HD SDI SD SDI WFM VIDEO OUT REF IN
REF OUT DIGITAL AUDIO
1 OUT1
OUT2 OUT 2
OUT 3
MONITOR
MONITOR (SUPER) SPARE
ACTIVE THROUGH
REMOTE OUT REMOTE IN/OUT
CONTROL PANEL
V/A CONTROL RS-232C
PARALLEL IN/OUT (50P)
SD
SD
SD
ON
OFF
FUSE 125V 5A
AUDIO OUT
AUDIO IN
MONITOR
TIME CODE
ACTIVE THROUGH 75 Ω 75 Ω
3
4 π 1
2 π 7
8 π 5
6 π
7
8 π 5
6 π 3
4 π 1
2 π
Video
Source Video
Switcher
Audio
Source Audio
Mixer
Digital video output
Digital video input
SD SDI OUT SD SDI IN
Digital
or
analog
audio
input
Digital or analog audio output