Panasonic AJ-HD3000 - Manual (Page 86)

– 86 –
TC/CHR CONVERT menu
Key
F3
F4
F5
F6
F7
F8
F9
F10
F11
Key designation
SYNC PHASE °
——
DF MD
RC_30SYS
24 TAPE LTC_OUT
EXIT
SUPR_FRQ
RC_TC °
SD SUPER
Description
For setting the reference for the 3:2 conversion sequence.
A: Frame A is used as the reference to convert the time code.
B: Frame B is used as the reference to convert the time code.
C: Frame C is used as the reference to convert the time code.
D: Frame D is used as the reference to convert the time code.
For selecting whether the 3:2 pull-down output from the 1080/23psf
(p) or 1080/24psf (p) format after it is converted into the time code
and output is to be in the drop frame or non-drop frame mode.
DF:
The output will be in the drop frame mode.
NDF: The output will be in the non-drop frame mode.
F6 (RC_30SYS) key appears when the 23.98 Hz has been
selected as the VTR system frequency.
Sets the 30 system edit mode with system format 24.
ON:
30 system editing
OFF: 24 system editing
F7 (24 TAPE LTC_OUT) key appears when the 25/50 Hz has
been selected as the VTR system frequency.
Sets the LTC OUT output (during 24 tape playback with
25 system).
ON:
LTC output according to tape format (24 tape TC)
OFF: 25 TC output
Returns the VTR to the TC/CHR menu screen.
For selecting whether to add the frequency information on the
time code superimposed display.
ON:
The frequency information is added. Example: 24LTCR
OFF: The frequency information is not added. Example: LTCR
For selecting the time code which is to be output to the remote
connectors (RS-422, etc.).
24TC: The original time code with the frame count of 24 is output.
30TC: The post-conversion time code with the frame count of 30
is output.
For selecting the time code which is to be output to the SD
monitor connector.
24TC:
The original time code with the frame count of 24 is
output.
30TC: The post-conversion time code with the frame count of
30 is output.
(25TC): The post-conversion time code with the frame count of
25 is output.