Panasonic AJ-HD3000 - Manual (Page 85)

– 85 –
TC/CHR CONVERT menu
This menu is displayed by pressing the following keys: )
∑ 2-level and 3-level time code displays
≥ Front panel
≥ When the 24 ➝ 30 mode has been selected by the F1 (MODE) key on the TC/CHR CONVERT menu, a
2-level display appears with the original time code displayed on the top level and the converted time code
displayed on the bottom level.
≥ When the 25 ➝ 30 mode has been selected, a 3-level display appears with the converted value displayed on
the middle and bottom levels.
F9 TC/CHR
Key
F1
F2
Key designation
MODE
——
Description
For selecting the time code format conversion mode.
24
>
30: The original 24-frame count display and 30-frame count
display mode is established.
(Window: 24TC/30TC display)
25
>
30: The original 25-frame count display and 24-and
30-frame count display mode is established.
(Window: 24TC/25TC/30TC display)
<Note>
When 24
➝ 30 is selected by the F1 (MODE) key and a 24 format tape is used, TCR 25TC will appear as
“ ¢¢ : ¢¢ : ¢¢ : ¢¢ ”.
TC_SYNC point setting
When the center cursor key is pressed, the 24TC display is highlighted. To enter the time code, use the num-
ber keys and cursor keys (
2 , 1 ) to set the time code, and then press the key. Move on to the
30TC/25TC value setting using the cursor keys ( 3 , 4 ), and proceed in the same way to set and enter the time
code.
ENT
F13
F12
F11
F10
F9
F8 F7 F6 F5 F4 F3 F2 F1
RC_30SYS
OFF
F13
F12
F11
F10
F9
F8 F7 F6 F5 F4 F3 F2 F1
RC_30SYS
OFF