Planet Technology IDL-2402 - Manual (Page 196)

‹ History Control
This table is for controlling the ETH History table (see next section). History Control 1 is
for controlling ETH History table 1; History Control 2 is for controlling ETH History table 2;
etc. Type in the Requested value and Interval (sec) and then click on New to create a
History Control entry. Up to 10 History Control entries can be created. To modify an entry,
click on the index to select the entry, type in new value, and then click on Modify. To
delete an entry, click on the index to select the entry and then click on Delete.
RMON History Control Table
Label Description
Data Source Data source identifies the source of the data for which historical data was
collected and placed in a table on behalf of this HistoryControl entry. Here the
source is GBE1 interface.
Owner An owner is the entity that configured this entry and is therefore using the
resources assigned to it.
Requested Requested value is the requested number of intervals over which data is to be
saved in the part of the media-specific table associated with this
HistoryControl entry.
Granted The number of sampling intervals over which data shall be saved in the part of
the media-specific table associated with thisHistoryControl entry.
Interval The interval in seconds over which the data is sampled for each bucket in the
part of the media-specific table associated with this
HistoryControl entry. The value range is 1 to 3600 (sec).
- 196 -