Planet Technology IDL-2402 - Manual (Page 216)

5.3 Enable Mode Commands
The commands in this section can be executed only in the Enable execution mode.
5.3.1 configure
Description Go to Configure execution mode from Enable mode.
Syntax configure
Parameter None
5.3.2 ping
Description ICMP echo and reply from hostname address or IP address. If no
reply for a long time, you can press Ctrl + c to interrupt ping.
Syntax ping {ipv4 address}
ping {ipv4 address} count <count>
ping {ipv4 address} size <size>
ping {ipv4 address} count <count> size <size>
Parameter
Name Description
ipv4 address IPv4 address.
Valid values: xxx.xxx.xxx.xxx (xxx:0~255)
Default value: -
count The number of PING packets sent.
Default value: -
size Packet size.
Default value: -
5.3.3 show access-list bcrate
Description Display all broadcast rate limiting list
Syntax show access-list bcrate
Parameter None
5.3.4 show access-list dstip
Description Display all dest IP deny access list or by index
Syntax show access-list dstip [<index>]
Parameter
Name Description
<index> Destination IP deny access list number.
Valid values: 1 ~ 256
- 216 -