Planet Technology IDL-2402 - Manual (Page 57)

3.6 Cluster Feature
The IDL-2402 supports Cluster feature that can make a group of NEs (network elements)
work together as a single NE from the management point of view. Operators can manage
the NEs in a cluster, called cluster nodes, via the same single IP address in terms of CLI,
Web-based GUI or SNMP based management interfaces. The IDL-2402 currently
provides cluster feature that a cluster can include up to four cluster members (NEs).
There are one Master and the other members are all Slaves in a cluster. The Master
works as a gateway of the Slaves, and it also can forward CLI/Web/SNMP commands to
the destination Slave. The Slaves can execute the commands and respond to the Master.
It uses star topology for conducting a Clustering Management group.
Figure 3-2 Cluster network topology – Star
Before you group a Master and a Slave IPDSLAM, some parameters need to be well
configured:
1. Cluster domain name: The group name for a cluster must be the same on
Master and Slave.
2. Cluster IP address: IP address to be used for remote management when Master
and Slave are grouped together.
3. NE cluster name: A name to identify Master or Slave.
4. Set private IP address on in-band port for both Master and Slave IPDSLAM. The
private IP is used for communication between Master and Slave. The
management center actually uses Cluster IP address for remote management.
5. Master and Slave need to be configured with same management VLAN.
6. The default gateway should be configured to the router that is aware how to route
management traffic to Management Center of the management network. The
setting of Cluster default gateway should be the same between Master and
Slave.
- 57 -