Planet Technology VIP-110 - Manual (Page 19)

IP Configuration Commands 7
3. IP Configuration Commands
This chapter describes the commands for configuring and displaying the IP interface
parameters. The configured parameter will not take effect until the configured parameter
is store in NVS and the ITG is reset.
This chapter is organized as follows:
l Commands for configuring and displaying LAN interface parameters
l Commands for configuring and displaying WAN interface parameters
l Commands for configuring and displaying DHCP server and client
l Commands for configuring TFTP server
l Commands for configuring and displaying PPPoE options
l Commands for configuring and displaying dynamic DNS related parameters
l Commands for configuring and displaying management options
l Command for storing IP interface parameters to NVS
Configuring LAN Interface
The section describes commands for setting and displaying LAN interface parameters.
net set lan ip
This command is used to assign a static IP address for the LAN interface
net set lan ip ip_addr
Syntax description
ip_addr IP address for the LAN interface.
Factory default
192.168.0.1
Related Commands
net set lan mask
net set lan mask
This command is used to assign the subnet mask for the LAN interface
net set lan mask mask
Syntax description
mask Subnet mask for the LAN interface.