Planet Technology VIP-110 - Manual (Page 49)

H.323 Configuration Commands 37
imtc Convey DTMF digits per IMTC specification.
Factory default
h323v2
Related Command
set h323 alt_dtmf
set h323 display_name
One of the UUIEs in the H.323 Setup message that the ITG sends to a remote gateway when
initiating a call is sourceAddress. The sourceAddress UUIE is a list of alias addresses, by which
the remote gateway identifies the ITG. This command is used to set a string that the ITG will
place in the 2 nd alias address filed of the sourceAddress UUIE in the H.323 Setup message.
set h323 display_name “display_name”
Syntax Description
display_name The string, up to 64 characters, to be is encapsulated the 2 nd alias
address field of sourceAddress UUIE of the H.323 Setup message.
Factory default
“Customer”
Related Commands
set h323 call_name
set h323 term_id
set h323 dtmf_duration
When the ITG employs IMTC relay mode, users may specify the duration the gateway plays
out a DTMF tone. This command is used to set the duration of a DTMF tone, when IMTC DTMF
relay technique is employed.
set h323 dtmf_duration milliseconds
Syntax Description
millisecond Duration for the DTMF tone in millisecond.
Factory default
300
set h323 gk_mode
The H.323 protocol allows calls to be established through H.323 gatekeeper. This command is
used to specify if calls are established through a gatekeeper.
set h323 gk_mode {off | manual}
Syntax Description
off Disable gatekeeper operation