Planet Technology VIP-110 - Manual (Page 39)

Telephony Interface Port Configuration Commands 27
set port_cfg fxs offhook_db
This command specifies the time in milliseconds to use as a debouncer interval for debouncing
the off-hook signal.
set port_cfg fxs offhook_db milliseconds
Syntax description
milliseconds Time in milliseconds, ranging from 1 to 1000.
Factory default
50
Related Command
set port_cfg fxs offhook_detect
set port_cfg fxs offhook_detect
This command is used to set the time to wait, in milliseconds, before an off-hook condition is
declared. For preventing from mistakenly interpreting noise signal or flash key as off-hook,
when a hook switch off state is detected on a FXS port, the switch off state must sustain for at
least this duration, otherwise it is no regarded as a off-hook.
set port_cfg fxs offhook_detect milliseconds
Syntax description
milliseconds Time in milliseconds, ranging from 1 to 1000.
Factory default
150
Related Command
set port_cfg fxs offhook_db
set port_cfg fxs onhook_db
This command specifies the time in milliseconds to use as a debouncer interval for debouncing
the on-hook signal.
set port_cfg fxs onhook_db milliseconds
Syntax description
milliseconds Time in milliseconds, ranging from 1 to 1000.
Factory default
50
Related Command
set port_cfg fxs onhook_detect