Planet Technology VIP-110 - Manual (Page 37)

Telephony Interface Port Configuration Commands 25
on page 31 for details about coding profile.
set port_cfg voice_prof profile_id
Syntax description
profile_id Preferred coding profile ID for voice
Factory default
The factory default preferred voice coding profile for all the telephony ports is coding
profile number 0, which is the coder for G.723 6.3 kbps.
show port_cfg
This command displays port-common parameters.
show port_cfg [pri | sec]
Syntax Description
pri Display the primary port-common parameters.
sec Display the secondary port-common parameters.
FXS Signaling Configuration Commands
The FXS signaling configuration commands are used to define parameters specific to FXS
interface. These commands apply to Loop Start FXS signaling protocol only.
set port_cfg fxs answ_clear_detect
This command is used to set the minimum time to wait, in milliseconds, when the answering
party drops the line before declaring on-hook.
set port_cfg fxs answ_clear milliseconds
Syntax description
milliseconds Time in milliseconds, ranging from 1 to 60000.
Factory default
2000
set port_cfg fxs caller_id
This command selects if Caller ID will be generated on a FXS port.
set port_cfg fxs caller_id {on | off}
Syntax description
on Enable Caller ID generation
off Disable Caller ID generation
Factory default
on