Planet Technology VIP-110 - Manual (Page 50)

H.323 Configuration Commands 38
manual Enable gatekeeper in manual discovery mode. The gk_addr must be
set appropriately.
Factory default
off
Related Command
H.323 Gatekeeper Related Configuration Commands
set h323 h245_term_type
This command is used to set the H.245 terminal type. The terminal type is used as part of the
master/slave determination process of H.245.
set h323 h245_term_type terminal_type
Syntax Description
termmal_type A numerical value designating the H245 terminal type. Typically,
setting the H.245 terminal type to a value less than 50 will force the
slave operation, and a value greater than 200 will force the master
operation.
Factory default
60
set h323 h245_timeout
This command is used to set the timeout value, in milliseconds, for an outgoing H.245 packet.
set h323 h245_timeout milliseconds
Syntax Description
milliseconds H.245 timeout value in milliseconds
Factory default
30000
set h323 h245_tunneling
In order to conserve resources, synchronize call signaling and control, and reduce call setup
time, it may be desirable to convey H.245 messages within the Q.931 Call Signaling Channel
instead of establishing a separate H.245 channel. This process is known as "tunneling" of
H.245 messages. This command is used to set tunneling feature.
set h323 h245_tunneling {on | off}
Syntax Description
on Turn on H.245 tunneling feature
off Turn off H.245 tunnelling feature
Factory default
off