Planet Technology VIP-110 - Manual (Page 35)

Telephony Interface Port Configuration Commands 23
tone
set port_cfg out_wait
This command is used to specify the time to delay after going off-hook before generating
outbound dial digits.
set port_cfg out_wait milliseconds
Syntax description
milliseconds Value is milliseconds, ranging from 0 to 65535.
Factory default
400
set port_cfg rxgain
The ITG adjust the power level of the PCM signal coming in from the telephony ports before
feeding it to the voice processor for further processing. This command allows user to specify
the gain level for PCM signal received from the telephony port.
set port_cfg rxgain db
Syntax description
db Gain level in dB, ranging from –14 to 14.
Factory default
0
Related Command
set port_cfg txgain
set port_cfg tone_out_off
This command is used to set the off time for DTMF tones for a telephony port.
set port_cfg tone_out_off milliseconds
Syntax description
milliseconds Value is milliseconds, ranging from 0 to 65535.
Factory default
200 ms
Related Commands
set port_cfg tone_out_on
set port_cfg tone_out_pwr
set port_cfg tone_out_on
This command is used to set the on time for DTMF tones for a telephony port.