Planet Technology VIP-110 - Manual (Page 48)

H.323 Configuration Commands 36
set h323 display_name
set h323 term_id
set h323 callSignalPort
Per ITU-T H.323 standard, the TCP port which the H.225 listens for incoming call setup
request is port number 1720. This command is used to configure the TCP port number which
the ITG listens for incoming call setup request..
set h323 callSignalPort port
Syntax Description
port TCP port number which the ITG listens for incoming H.225 call setup
request
Factory default
1720
set h323 cisco_t38
Cisco FoIP solutions support standard T.38 fax. However, they expect their peer gateways
initiating Open Logical Channel (OLC) request, when it determines itself as a H.323 Master.
For the ITG to be aware of initiating OLC request when interoperating with Cisco gateway, this
command is provided.
set h323 cisco_t38 {on | off}
Syntax Description
on Initiates H.323 OLC under slave mode.
off Waits for H.323 OLC from maser under slave mode.
Factory default
off
set h323 default
This command resets the all the H323 related parameters to factory default values.
set h323 default
Syntax description
This command has no arguments or keywords
set h323 default_dtmf
There are two ways VoIP gateway handles DTMF relay, per H.323 and IMTC specifications. By
default, the ITG conveys DTMF digits in H.323 format. This command is used to specify how
DTMF digits are to be conveyed to a remote VoIP device.
set h323 default_dtmf {imtc | h323v2}
Syntax Description
h323v2 Convey DTMF digits per H.323 specification.