Printronix L1524 - Manual (Page 101)

3–61 Configuring the Printer
ERROR: NVRAM
FAILURE The non-volatile memory has
failed. Contact service provider.
(Do NOT attempt to
replace NVRAM.)
ERROR: PROGRAM
NEEDS MORE DRAM The printer requires more DC
DRAM memory in order to run
the downloaded program, or in
order to use the downloaded
files. Use a smaller emulation
program or have your
service provider add DC
DRAM to the controller
board.
ERROR: PROGRAM
NEEDS MORE FLASH The printer requires more DC
flash memory in order to run the
downloaded program, or in
order to use the downloaded
files. Optimize the flash file
system. (See page
3–46.) If the message
persists, use a smaller
emulation program, or
have your service
provider add DC flash
memory to the controller
board.
ERROR: PROGRAM NOT
COMPATIBLE The downloaded program is not
compatible with the printer. Use the correct
emulation software
option(s) for this printer
model.
ERROR: PROGRAM NOT
VALID The printer did not detect an
emulation program in DC flash
memory, or the emulation
program in DC flash memory is
present but corrupted. Power off the printer and
download the program. If
the message persists,
contact service provider.
ERROR: SECURITY PAL
NOT DETECTED The security PAL is not present
or has failed. Contact service provider
ERROR: SHORT AT
ADDRESS
xxxx
Hardware failure in DC DRAM
or in controller board circuitry. Contact service provider.
ERROR: WRITING TO
FLASH Hardware or software fault in
DC flash memory. Power off the printer and
download the program
again. If the message
persists, contact service
provider.
ERROR: WRONG
CHECKSUM The printer received the
complete program or data file,
but the checksum did not match.
The data were corrupted during
download. Power off the printer and
download the program
again.