Printronix L1524 - Manual (Page 48)

3–8 Configuring the Printer
Saving Configuration
The following is displayed to indicate the configuration has been saved:
Save Config.
(selected number) *
7. It is recommended you print the configuration and store it in a safe place
for future reference. Refer to page 3–11 for details on printing the
configuration.
NOTE: If you want to make these new configuration parameters active at
printer power-up, make sure you select this configuration as the
“power-up config” (page 3–19 ).
Modifying a Configuration
You can change a saved configuration by “writing” over it. For example, you can
modify Config. 1, shown below. Suppose you want to keep all settings except the
interface type (e.g., you want to change RS–232 to Centronics). It is necessary to
load a configuration, make the desired changes, delete the current “copy” of the
configuration, and save the current machine configuration (in this example,
configuration 1 with the desired changes) as the newly modified configuration.
Config. 1: Selects RS–232 Serial Interface
Selects Image Width of 4 inches
Selects Paper Length of 24 inches
Selects Image Shift of 1 inch, etc.
1. Load the configuration to be changed (for example, Config. 1).
a. Press ON LINE to take the printer offline.
OFFLINE
CONFIG. CONTROL
b. Press DOWN.
CONFIG CONTROL
Load Config.