Printronix L1524 - Manual (Page 78)

3–38 Configuring the Printer
Buffer Size In K
This option configures the amount of memory allocated for the IEEE 1284 parallel
port buffer. You can specify between 1 and 128 KBytes.
Ethernet Parameters Menu
Host
Interface
IP
Address
Gateway
Address
Subnet
Mask
xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx
MAC
Address
Novell
Protocol
NetBIOS
Protocol
hh.hh.hh.hh.hh.
hh Enable*
Disable
Novell
Frame
PPM Port
Number
PPM Port
Timeout
Auto Sensing*
Ethernet II
Ethernet 802.2
Ethernet 802.3
802.2 Snap 1023
.
.
3001*
.
.
65535 100 secs. *
(1–255)
Enable*
Disable
* = Factory Default
1 = If Installed
IEEE 1284 Centronics Dataproducts Serial Autoswitching Coax Twinax Ethernet 1
Available only
in CT option
Available only
in CT option
Figure 3–11. Ethernet Params
The ETHERNET PARAMS menu enables you to set up your printer so it can
communicate on a network. For information on assigning the IP Address,
Gateway Address, Subnet Mask and MAC Address, refer to the PrintNet User’s
Manual. You may also enable or disable the Novell or NetBIOS Protocols within
this menu, as well as selecting which Novell Frame scheme is used in processing
Novell signals. See the Novell chapter in the PrintNet User’s Manual for more
details.If the printer is connected to a Printer Manager utility, the PPM Port
number and PPM Port Timeout settings must match the settings in the Printer
Manager program. See the appropriate Printer Manager Manual for details.