Printronix L1524 - Manual (Page 25)

2–7 Setting Up the Printer
Initial Setup
To prepare the printer for operation, install the consumables that are packaged in
consumable kits within the consumable ship set box. They are:
•
Developer unit (Developer Kit)
•
Starter Toner (Developer Kit)
•
Ozone filter (Developer Kit)
•
Waste toner container (Toner Kit)
•
Fuser cleaner felt (Toner Kit)
•
OPC drum unit
NOTE: The material in the toner kit is recyclable. Save the toner box and
packaging materials for recycling. A recycling shipping label is
provided with instructions attached.
To install the consumables, perform the following procedures in the order
presented.
Install the Developer Unit
CAUTION
Do this procedure only if this is the initial installation and no toner has
been added to the developing unit. Otherwise, fill the toner hopper with
toner from the toner bottle.
1. Raise the top of the printer by firmly pressing the top cover latch on the
left of the front panel. (See Figure 2–5.)
2. Remove the new developer unit from its foil package.
3. Slide the developer unit along the plastic rails on either side of the printer
until the developer unit is in position.
4. Lock the developer unit in place by pushing the two green lock-down
clamps down until they click.