Printronix L1524 - Manual (Page 66)

3–26 Configuring the Printer
Data Polarity
This parameter must be set to match the Data Polarity of your host computer.
Standard: Does not expect the host computer to invert the data.
Inverted: Expects the data received on the data lines from the host computer to
be inverted. Ones become zeros and vice versa.
Resp. Polarity
The Response Polarity parameter must be set to match the Response Polarity of
your host computer.
Standard: Does not invert the response signal.
Inverted: Inverts the response signal sent to host computer.
Busy On Strobe
Enable: Asserts a busy signal only when the print buffers are full.
Disable: Asserts a busy signal after each character is received.
Latch On Data
Specifies whether the data is read on the leading (default) or trailing edge of the
data strobe signal.
Prime Signal
Enable: The parallel port will do a warm start (reboot) if the host asserts the
Prime Signal.
Disable: The parallel port will not do a warm start (reboot) if the host asserts the
Prime Signal.
TOF Action
Reset : A form feed is done before a warm start when the Prime Signal is
asserted from the host. This setting is only used if the Prime Signal parameter is
asserted.